SWS ALUMTIG 20, Руководство по эксплуатации

Страница: 24 / 26

Manual Version 1.3 - June/2017
20
ALUMTIG 200
ALUMTIG 200
8.10 Arc difficult to start or will not start DC welding
8.11 Arc difficult to start or will not start DC welding
POSSIBLE REASON SUGGESTED SOLUTION
Incorrect machine set up Check machine set up is correct.
No gas, incorrect gas flow Check the gas is connected and cylinder valve open,
check hoses, gas valve and torch are not restricted.
Set the gas flow between 15–25 CFH (7–12 LMN)
flow rate.
Tungsten is contaminated Remove 3/8” (10mm) of contaminated tungsten and
re‑grind the tungsten.
Incorrect tungsten size and or tungsten being used Check and change the size and or the tungsten if
required.
Loose connection Check all connectors and tighten.
Ground clamp not connected to work Connect the ground clamp directly to the work
piece wherever possible.
Loss of high frequency Check torch and cables for cracked insulation or
bad connections.
POSSIBLE REASON SUGGESTED SOLUTION
Incorrect machine set up Check machine set up is correct.
No gas, incorrect gas flow Check the gas is connected and cylinder valve open,
check hoses, gas valve and torch are not restricted.
Set the gas flow between 15–25 CFH (7–12 LMN)
flow rate.
Incorrect tungsten size and or tungsten being used Check and change the size and or the tungsten if
required.
Tungsten is contaminated Remove 3/8” (10mm) of contaminated tungsten and
re grind the tungsten. Use a pointed tungsten with
AC squarewave inverter machines. The point will
round off after welding.
Loose connection Check all connectors and tighten.
Ground clamp not connected to work Connect the Ground clamp directly to the work
piece wherever possible.
Loss of high frequency Check torch and cables for cracked insulation or
bad connections.
7. GTAW (TIG)