SWL remote control for ICOM, Руководство по эксплуатации

Страница: 9 / 13

9
Copyright © 2003, 2004, 2005 by swl-remotes.com,
All rights reserved.
Configuration Parameters
0 9 1 Enter
Set CI-V address
x x Enter CI-V address set to xx
or
x Mute y Enter y converted to hex (e.g. 1 – A, 2 – B, etc)
5A would be entered as: 5 Mute 1 Enter
0 9 2 Enter
Set Radio Port baud rate
1 9 Enter 19200 Baud
9 6 Enter 9600 Baud (Factory Default)
4 8 Enter 4800 Baud
1 2 Enter 1200 Baud
0 9 3 Enter Set RS-232C Level Converter baud rate
1 9 Enter 19200 baud (Factory Default)
9 6 Enter 9600 baud
4 8 Enter 4800 baud
0 9 4 Enter Set Frequency Pacing
x x Enter Value from 1 to 99 to control pacing. 1 is the fastest and
99 is the slowest.
0 9 5 Enter Set Configuration Parameters to Factory Defaults.
Enter Reset Configuration Parameters to Factory Default.
CI-V 5A
Radio Baud 9600 baud
Frequency Pacing 30
Optional Modes Disabled
0 9 6 Enter Enable/Disable Optional Mode Selections
0 Enter Disable FM and CW modes in selections.
(Factory default)
1 Enter Enable FM mode in selections.
2 Enter Enable CW mode in selections.
3 Enter Enable both FM and CW in mode selections.
4 Enter Disable AGC off (Factory default)
5 Enter Enable AGC off in AGC selections.
0 9 7 Enter Define User Tuning Steps
x Mute f f f f Enter
The User Tuning step x (1, 2, 3, 4, or 5) is defined as frequency ffff ,
converted to f.fffkHz. You must enter all digits, even zeroes; e.g. define
Tuning Step 2 with a value of 1.4kHz would be
2 Mute 1 4 0 0 Enter .
The display on the radio will show the value as 2.140.000Hz when you
are done to confirm the entered value. It is best to set these tuning steps
with the receiver on and in the VFO mode. These steps are saved in non-
volatile memory and are never changed except using this configuration
mode.