22
2. "Parent Unit" (Receiver)
Make sure that the batteries are installed or the adapter is
connected correctly.
Place the "parent unit" near to the parents’ location (Fig. V).
Turn the POWER/VOLUME control on and adjust volume as
required, the power indicator LED will light up. If a sound signal is
received from the "baby unit", the "Parent unit" indicator LED will
light up.
3. Channel Selection
The unit set 2 different channels for radio Signal transmission. If
the reception is poor or interference radio Signals are being
picked up, please change switch to the other channel in order to
get optimum reception.
Always make sure that channel switches to the same chan-
nel for both units.
4. Tuning The Voice Activating Sensitivity
In normal circumstance the factory preset sensitivity level to the
most applications is recommended, unless you feel voice
transmission difficult, you can use a flat screwdriver to adjust it as
below (Fig.VI):
a) To turn clockwise to increase sensitivity.
b) To turn counter anti−clockwise. to reduce the sensitivity.
5. Belt Clip
After the batteries is connected to the "parent unit", you can carry
it for your convenience at your home by using the belt clip.
(Fig. VII )
6 Trouble Shouting
1. Non−operation situation
Check the "baby unit" and the "parent unit" is at the same
channel.
Ensure the "baby unit" and the "parent unit" batteries or power
adapter are connected properly.
2. Wireless RF transmission range too small
Check if the battery is Iow. If so, please replace new batteries
Check if there is interference, remove the interference source.
Adjust voice sensitivity according to point 4 in Operation section
to get Optimum transmission.
