SWITCH MADE LS1911B, Руководство пользователя

Страница: 5 / 13

Wiring at the installation location (mains supply) 1
Fixe the clips on the rubber plug or plate
7 Connect the strip wire in the profile with the output line of the power supply 8
Install the power supply at a proper location 2
Do not touch with wet hand or there is risk of electric shock
Place insulation on both ends of the strip and place the strip on the profile 3 Mount the diffuser on the profile (K, C or P diffuser to be selected depending
on the application demand)
4
Mount the end caps (with and without hole) 5 Make an hole of φ 5mm at the mounting position and seal it with a rubber
plug
6
Do not place the power supply in water or remove it without permission
Strips with exposed copper foil on the back shall be insulated
End cap
End cap with hole
LED-
LED+
DIM-
DIM+
Driver
GND
AC-N
AC-L
Connect to DIM
LED-
LED+
DIM-
DIM+
Driver
GND
AC-N
AC-L
Connect to DIM
-
+
LED
If assembling is required, please read the detailed profile assembling steps on P08
and do it in the correct way
If the product is mounted on a plate, skip the step
The number of clips to be used depends on the profile length (L):
·When L ≤ 1.2m, 2pcs of clips are recommended
·When 1.2m ＜ L ≤ 2.5m, 4pcs of clips are recommended
For an end cap without hole, wire goes out from the profile bottom, while it goes out
from an end cap with an hole of φ 6mm
w w w . s w i t c h - m a d e . c o m
SWITCH MADE
USER MANUAL