SWITCH MADE LS1911B, Руководство пользователя

Страница: 11 / 13

Cutting
1 Mount the diffuser on the profile 2
Profile cutting by a cutting machine
It is recommended to set the speed at 1,000 – 1,200rpm. Too high a speed may cause
damage to the diffuser
A light source is not slowed to be placed on the profile during cutting
Please make sure the product is firmly fixed during cutting. The break shall be ground
smooth to remove burr after cutting, and metal chips shall be completely removed from inside the track
3 4 Cut the strip to match the profile and weld the red and black wire on one
end of the strip
4
5
24V+ 24V+
24V - 24V -
24V+ 24V+
24V - 24V -
24V+ 24V+
24V - 24V -
24V+ 24V+
24V - 24V -
24V+ 24V+
24V - 24V -
24V+ 24V+
24V -
24V -
24V+
24V+
24V - 24V -
24V+
24V -
24V+
24V -
φ 8mm
When the wire goes out from the end cap, it is unnecessary to make an hole
in the profile. When it goes out from the profile bottom, an hole is to be made,
as shown in the figure below
Mark the length to the cut off (profile loss will occur during cutting by about
the thickness of the blade), and please make reservations of profile length
When the wire goes out form the end cap, the length to be cut off is a multiple of the
minimum cutting unit of the strip. See Figure 1
When the wire goes out from the profile bottom and end cap, the length to be cut off
is a multiple of the minimum cutting unit of the strip + wire length going out (8mm).
Multiple of the minimum cutting unit of the strip
The length of wire
Cutting point
Loss
2500
w w w . s w i t c h - m a d e . c o m
SWITCH MADE
USER MANUAL