FIGURE 13
exit section
FIGURE 14
1-1/2" bolt
2" x 4" x 8-1/4"
2" x 4" x 7"
2" x 4" x 18"
2" x 4" x 18"
2-1/2" screws
2-1/2" screws
washer
loc nuts
2" x 4" x 8-1/4"
FIGURE 16
FIGURE15
1-1/2" lag bolts
support bracket
Fig. 6
Fig. 6a
Fig. 6b
Fig. 6c
F. SUPPORT AND BRACKET
ASSEMBLY
1.
Position the slide bracket as shown in
(FIG. 6)
.
Remove appropriate bolts from the slide (the fourth and
fifth bolts as indicated), Attach bracket to the underside
of the seam using the previously removed hardware
(FIG. 6)
.
2.
Using holes in the bracket (indicated by arrows in
(FIG. 6)
) as a guide, mark and drill 1/8" pilot holes
(1" deep).
NOTE
: You may need to temporarily
remove the slide bracket to drill the pilot holes.
3.
Re-attach bracket (if necessary) and secure it to the
4'' x 4'' Slide Support using two 1-1/2" lag bolts .
4.
Assemble the support base as shown in
(FIG. 6a)
.
5.
Attach the support bracket to the support base using
two 1-1/2" lag bolts
(FIG. 6c)
.
NOTE:
Pre-drill 1/8" pilot holes.
6.
Place the support beneath the slide base and determine
its final position.
NOTE:
Slide support should fit tightly
beneath the slide to assure proper support. Remove
corresponding nut and bolt, attach support to the slide
as indicated in
(FIG. 6b)
. Re-attach hardware.
7.
Level grade at the bottom of the slide.
slide bracket
4
''
x
4
''
x
6
6
''
Tunnel Twister Assembly Instructions
9