Swing-N-Slide PB 8205, Руководство по сборке

Страница: 23 / 48

23
PB 8228 - PB 8205 Assembly Instructions
L. Swing Beam Hardware
1. Flip 4'' x 4'' Swing Beam over so that the opposite side of your drilled holes are facing upwards.
2. Place one (1) Wood Loc Washer on each Carriage Bolt with tangs facing downward.
3. With a hammer tap bolts through drill holes in Swing Beam until Tangs sink fully into the wood as shown in
(Fig. 17) .
4. Flip the 4’’ x 4’’ Swing Beam over so that bolt tips are facing upwards. Apply Timber Wrap to 4'' x 4'' using
the bolt tips as a guide as shown in
(Fig. 17a) . Tigthly wrap TimberGlove around 4’’ x 4’’ Swing beam and
using the hook and loop strips secure Timber Glove in place.
5. Install (1) 1-1/4'' screw through the Hook and Loop seam every 12’’ along 4'' x 4''.
Note: Do not sink 1-1/4'' screw head through TimberGlove fabric. Doing so can cause TimberGlove to become
loose over time. Make Screw Head flush with surface of TimberGlove.
WOOD LOC
WASHER
Fig. 17
Fig. 17a
4'' CARRIAGE BOLTS
FOR A-FRAME
4-1/2'' CARRIAGE BOLTS
FOR SWING HANGERS