Swing-N-Slide Four Foot Tower, Руководство по сборке

Страница: 27 / 89

26
Four Foot Tower Assembly Instructions
Ladder Assembly.
1. Attach 2’’ x 3’’ to unit as shown in (Fig. 23).
2. Assemble Ladder by Laminating 5/4’’ x 4’’ x 46-1/4’’ boards as shown in (Fig. 23a). Make certain to measure the spacing of
the ladder rungs accurately to avoid a bad opening.
3. Attach the ladder to the unit as shown in (Fig. 23b).
Note: To avoid a possible entrapment issue, make sure to attach the Ladder Rung so that the body of the Rung is facing
inward (towards the underside of the unit).
Fig. 23b
2-1/2’’ screw
(2)
2-1/2’’ screws
per joint
2’’
x 3’’
x 47’’
Fig. 23
Fig. 23a
(2) 5/4’’
x 4’’
x 46-1/4’’
Per
Side
(2) 1’’ x 4’’ x 15-1/2’’
9-7/8’’
21-7/8’’
33-7/8’’
2-3/4’’
15-1/2’’
ATTENTION:
These Images Show The Back
Side of The Unit
(3)
3’’ screws
per joint
3’’ screw
1-1/2’’ screw
1-1/4’’ Lag screw
(2)
1-1/2’’ screws
per joint
(6)
1-1/2’’ screws
per side
(2)
1-1/4’’
Lag screws
per rung
LADDER ASSEMBLY
TO AVOID A POSSIBLE ENTRAPMENT ISSUE, MAKE SURE TO ATTACH THE
RUNG SO THAT BODY OF THE RUNG IS FACING INWARD.
BODY OF RUNG MUST
FACE INWARD
ANCHORING YOUR TOWER
Unit tip over can result in serious injury to your child. Four Anchor-Its are
provided with your tower. These must be used to secure all four corners of
the tower. Additional Anchor-Its are provided with other modules and must
be installed accordingly. If you are not adding a swing beam to your
tower, heavy duty anchors MUST be used to secure your tower to
the ground on all four corners. Heavy duty anchors can be purchased
at Lowes under item number 89373, model AK4. If you live in an area that
soil conditions permit Anchor-Its to be pulled out easily, or that is subject to
high winds, Swing-N-Slide strongly recommends that you purchase and
install the heavy duty anchors on all unit configurations.
ADDENDUM
2-3/4
Body of Rung Must
Face Inward