Swarts Tools SWB1705, Инструкция пользователя

Страница: 7 / 14

ALWAYS CHECK YOUR GRINDING WHEELS PRIOR TO USE:
CHECK FOR CRACKS, DEBRIS OR CHIPS. DO NOT USE THEM IF THEY APPEAR THIS WAY!
NOTE: We have provided you with extra bolts should you choose to mount the sharpener to the wall
SETTING UP THE CHAINSAW SHARPENER
SWB1705
05
MOUNTING & ASSEMBLY
CHAIN IDENTIFICATION
It is important to ensure this tool is securely mounted to a sturdy bench or upright post, using the bolts
provided. There is a notch in the bottom of the base to show you how far forward to mount this tool onto
your bench.
Prior to setting up the angles on the sharpener, it is important to identify the model and specifications of
your chain. To ensure you are use the correct discs and angles required, these is generally an
identification number on the multiple teeth of your chain. This can then be used with the chart provided
on the last page of this manual to obtain the correct model and specifications needed.
If you cannot identify your chain, you can use the blue template provided or contact the chain
manufacturer.
1. Sit the base (2) on your bench with the front overhanging (approx. 140mm overhang)
2. Rest the back of the mounting notches (5) against the front edge of the bench. This is the correct
positioning for your sharpener
3. Mark and drill your mounting holes into the bench
4. Slot two of the 80mm bolts through the base and into your bench
5. Tighten using the nuts provided (the nuts need to sit beneath the bench)
6. Slot the cross shaped locating pin on the back of the top motor section (1) into the centre hole of the
base
7. Insert the 45mm bolt into the hexagonal slot of the top motor section and into the base (2)
8. Slip on the washer provided and install the large black locking knob. Tighten