Swarts Tools SWB1705, Инструкция пользователя

Страница: 10 / 14

SHARPENING THE CHAIN
SWB1705
08
DRESSING THE WHEEL
After a certain amount of time, the edge of the grinding wheel will become misshapen.
Use the blue template provided, check which slot your wheel fits into. These slots are a template
to show the correct shape of the wheel.
Use the dressing stone to shape the wheel to match the curve in the blue template
2. Carry out a test grind on one tooth and adjust accordingly any setting angles if required
3. Cycle through all the left-hand teeth of the chain
4. Loosen the vice locking knob (11) carefully
5. Rotate the vice section (6) to face the opposite side
6. Lock the vice locking knob (11)
7. Check all settings and angles are correct. Perform a test grind on a single tooth again
8. Now you can sharpen the opposing teeth.
NOTE: ensure that you do not place your whole weight on the machine or force it down. Only minimal
pressure is required, so that the wheel is only just skimming the surface of the tooth
NOTE: This tool uses an induction motor. By design, they get very warm. This heat is completely
normal.
NOTE: It is important to remember that if you are not starting off using this machine with a brand-new
chain, that it is not uncommon for the teeth to be different lengths. This is especially common when
chains have previously been hand sharpened. In this instance, you may need to reset the chain back
stop for every tooth to ensure an optimal sharpen.