swaploader SL-214, Руководство по эксплуатации и частям

Страница: 42 / 106

Section II: Installation - Accessories
2.6.INS.ACC.11H99
12. Remove both the hydraulic hose ( Pt. No. 12P55 ) that connects from the upper bulkhead
fitting inside the Main Frame to the jib lockout valve ( Pt. No. 21P28 ) and the 90 degree
hydraulic fitting ( Pt. No. 11P23 ) installed into the top side of the jib lockout valve (see Pg. 2-
28 ).
13. Replace with hydraulic fittings ( Pt. No. 12P69 (Qty: 2) & 13P03 ), hydraulic hose ( Pt. No.
11P98 ), and relief valve assembly ( Pt. No. 21P93 ) and tighten (see Pg. 2-28 ).
14. Refill hydraulic tank to proper fluid level.
15. Verify that the CVS is operating properly. Start the truck, engage the P.T.O., and then
retract the jib cylinder full stroke. Next, while extending the jib cylinder back out have
someone push or rotate the CVS lever arm forward (toward the back of the truck cab). The
CVS is operating properly when the jib cylinder stops extending by rotating the CVS lever
arm forward.
16. Containers to be used in conjunction with the CVS need modified by adding a stop tab to the
side of the container longsill (see Pg. 2-29 ). Dimensions given are a recommendation only.
When modifying containers for use with the CVS it is the primary responsibility of the
installer to verify that adequate rear end overhang and full latch plate engagement into body
locks exists for each container.
2-30