Swagelok TF16, Руководство пользователя, Страница: 19 / 24

Tube Facing Tool User’s Manual 19
Processing the Tube
•
WARNING
When cutting, do not exceed a chip thickness of
0 002 in (0 05 mm)
■
Move the tool towards the tube by means of the feed
handle until the tool touches the tube.
■
If the cutting edge of the tool is cutting into the entire
circumference of the tube, guide the tool further with
the same amount of pressure.
•
WARNING
The dial can be set to zero in accordance with
the marking on the housing Each division mark
corresponds to a feed motion of 0 002 in (0 05 mm)
Switching the Machine Off
■
Release the ON/OFF switch.
■
Disconnect the mains plug from power source/
remove the battery from the battery drive.
■
Release the tube from the machine.
■
Remove the chips from the housing with suitable
tools (tongs) after each machining process.
■
Close the cover after removing chips.