21
Operating Maintenance Installation CLASSIC PIZZA 860005-02
UNPACKING
Open the packing materials carefully so that the oven is not damaged. Inside the oven chamber there are several
parts which must be used during assembly. Take these out and check with the enclosed packing list. They should
include the adjustable feet or castors, distance bumper, consoles for unloading shelf, screws, nuts, mounting manual
and washers for cable inlet. On top of the oven there should be unloading shelf, canopy and oven legs.
2c
2b
2a
1
7
8
3
6
5
4
9
Read carefully through this manual before unpacking the oven.
Incorrect handling can damage the oven during transport and installation.
Assembly of oven parts.
Fig. 12 Dismantling of Classic Pizza.
1
Unscrew the cover plates at the front of the oven. On
ovens with one oven section there are two cover
plates, and on other ovens three or more.
2
Loosen the screws which connect the top section
with the top (
2a
) and the screws between the sections
(
2b
). If necessary the screws which connect the
bottom section with the bottom (
2c
) can also be
loosened. Read more about this in item 6.
3
Loosen the screws which connect the right-hand
front panel with the top, and the screws between the
front panels, and if necessary also the screws between
the front panel and the bottom.
4
Loosen the screws at the back of the oven along the
joint between the section and the top, between the
sections, and if necessary between the bottom section
and the bottom.
5
Mark up and loosen the cables in the distribution box
which are drawn between the sections and shall be
separated. The thick power cables (4-5 pcs) are
appropriately loosened at the automatic fuses, the
thinner cables (2 pcs) are loosened at the terminal
blocks.
6
The bottom section and the oven bottom should not
be separated. If it is necessary to separate the oven
also here, do as follows:
Begin by marking up where and how all the element
cables are positioned, and then loosen these.
7
Loosen the cover plate behind the cables and lift this
off the insulation material behind.
8
Loosen the three screws with their clamp washers so
that the underlying plate strip releases. The oven
section can now be lifted off.
When the oven is to be assembled again it is important
that the plate strip is clamped again
under the washers.
Now replace the insulation material, fit the cover
plate (
7
) and connect up the element cables again.
9
It is very important that the cables are correctly
located, and that both cup washers are turned
towards each other before they are screwed together.
