PERIODIC MAINTENANCE 2-5
• Remove the drain plug
1
to allow any water to drain out.
• Reinstall the cleaned air cleaner element in the reverse order
of removal.
"
"
VALVE CLEARANCE
REMOVAL
• Remove the seat. (
!
5-3)
• Remove the fuel tank. (
!
4-2)
• Remove the spark plug. (
!
2-7)
• Remove the valve inspection caps
1
.
• Remove the valve timing inspection plug
2
and generator
cover plug
3
.
Be sure to position the element snugly and correctly,
so that no incoming air will by-pass it. Remember, the
rapid wear of piston rings and the cylinder bore is
often caused by a defective or poorly fitted element.
If driving under dusty conditions, clean the air cleaner
element more frequently. The surest way to accelerate
engine wear is to operate the engine without the ele-
ment or to use a torn element. Make sure that the air
cleaner is in good condition at all times. The life of the
engine depends largely on this component!
Inspect initially at 1 000 km (5 months) and every
4 000 km (20 months) thereafter.
Содержание RV125
