9
Insert the choke cable into the hole of lower housing.
Insert the choke cable end into the recess in the choke
lever.
A: Choke cable end
B: Hole
C: Lower housing
D: Choke lever
Insert the boss of lower housing into the hole on the
handlebars.
Install the left switch upper housing and tighten the left
switch assembly with the two screws.
Fasten the choke cable holder on the front screw.
A: Boss
B: Hole
C: 5 × 44 mm screw
D: 5 × 25 mm screw
E: Cable holder
CLUTCH MASTER CYLINDER
Install the clutch master cylinder onto the handlebars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
"
Clutch master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: Holder
B: Clutch master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
NOTE:
Before installing the cable, grease its cable
end.
NOTE:
To install the holder correctly, first tighten the
bolt
C
of the upper side with specified torque
and then tighten the bolt
D
of the lower side.
