7
#
A: Front brake hose
B: Throttle cables
C: Right switch wiring harness
D: Clutch hose
E: Left switch wiring harness
F: Choke cable
THROTTLE
Insert the boss of the throttle lower housing into the
hole on the handlebars.
Tighten the throttle assembly with two screws.
#
A: Boss
B: Hole
C: 5 × 29 mm screw
FRONT BRAKE MASTER CYLINDER
Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
"
Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: Holder
B: Front brake master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
The line drawings on page 29, 30 and 31 show
the proper routing of the control cables, hose
and wirings.
Refer to them in addition to following the
instructions carefully.
Check to ensure that the throttle operates
freely and closes automatically.
NOTE:
To install the holder correctly, first tighten the
bolt
C
of the upper side with specified torque
and then tighten the bolt
D
of the lower side.
