Suzuki Grand Vitara 1998, Руководство по обслуживанию

Страница: 725 / 801

YH4
GRAND
VITARA
(A)
“A5”
1. Combination meter connector (16p)
2. “Y / G” wire terminal
1. Connection detection pin
AIR BAG SYSTEM 10B-19
TABLE B – “AIR BAG” WARNING LAMP DOES NOT COME “ON” (Page 2 of 2)
STEP ACTION YES NO
4 1) Remove combination meter, referring to
SECTION 8C.
2) Check proper connection to combination
meter at terminal for “AIR BAG” warning lamp
and to SDM at terminal “A5”.
3) If OK then check resistance between “Y / G”
wire terminal of combination meter connector
(16p) and “A5” terminal of SDM connector.
4) Is resistance 1 or less?
Go to step 5. Repair high resistance
or open in “BI” or “Y / G”
wire circuit (between
combination meter and
SDM).
5 1) Measure voltage from “A5” terminal of SDM
connector to body ground with ignition switch
ON.
2) Is it 9 V or more?
Repair short from “BI” or
“Y / G” wire circuit
(between combination
meter and SDM) to
power circuit. Go to step 6.
6 1) Remove and inspect “AIR BAG” bulb.
2) Is bulb good? Substitute a known-good
combination meter and
recheck. Replace bulb.
Fig. for STEP 2 Fig. for STEP 3 and 5
Fig. for STEP 4
Special Tool
(A): 09932-76010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat “Air Bag Diagnostic System Check Flow Table”, referring to p.10B-11 to confirm that the trouble
has been corrected.