Suzuki Grand Vitara 1998, Руководство по обслуживанию

Страница: 628 / 801

YH4
GRAND
VITARA
1. Molding
2. Fastener
1. Molding
2. Adhesive
3. Glass
“A”: Primer for molding
1. Rubber sucker grip
9-10 BODY SERVICE
7) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to body.
NOTE:
Be sure to refer to maker’s instruction for proper han-
dling and drying time.
Do not apply primer on outside of ceramic coated sur-
face.
Do not touch primer coated surface.
Width “b”: 18 – 19 mm (0.71 – 0.75 in.)
“c”: 16 – 17 mm (0.63 – 0.67 in.)
“d”: 24 mm (0.94 in.)
“e”: 27 mm (1.06 in.)
8) Apply primer for molding along molding surface all around as
shown in figure.
9) Apply adhesive referring to figure at the left.
NOTE:
Start from bottom side of glass.
Be careful not to damage primer.
Height of adhesive applied to lower side should be high-
er than that of other three sides.
Upper, right and left sides
Width
“e” : Approx. 11 mm (0.43 in.)
Height “f” : Approx. 17 mm (0.67 in.)
“g” : Approx. 25 mm (0.98 in.)
Distance “h” : Approx. 16 mm (0.63 in.)
Press glass against body quickly after adhesive is ap-
plied.
Use of rubber sucker grip is helpful to hold and carry
glass after adhesive is applied.
Perform steps 9) to 10) within 10 min. to ensure sufficient
adhesion.
Be sure to refer to adhesive maker’s instruction for prop-
er handling and drying time.
10) Holding rubber sucker grips, place glass onto body by aligning
mating marks marked in step 3) and press it.