Suzuki Canvas SQ416, Руководство по обслуживанию

Страница: 197 / 731

J2
ESCUDO
FRONT SUSPENSION 3D-19
“B”
Press-fitting inner oil seal.
Drive in inner oil seal until its end contacts stepped surface of
knuckle using special tools.
Special Tool
(B): 09944-66010
(C): 09924-74510
Apply lithium grease to oil seal lip and into its hollow to fill more
than 60% of its vacant space.
“B”: Grease 99000-25010
Bending ball stud split pin. (For castle nut type)
After tightening ball stud castle nut, bend split pin so that it is in
close contact with stud head or castle nut as shown. Also, be sure
to insert its bent end so that its projection (“A” in figure) is made
as small as possible.
Tightening Torque
(a): 55 N
.
m (5.5 kg-m, 39.0 lb-ft)
Tighten control arm ball stud nut. (For self-locking nut type)
When tightening ball stud nut, use new nut and tighten it to speci-
fied torque.
Tightening Torque
(b): 60 N
.
m (6.0 kg-m, 43.5 lb-ft)
When installing axle shaft drive flange to wheel hub, apply sealant
to mating surface of axle shaft drive flange.
“A”: Sealant 99000-31090
Tightening Torque
(a): 25 N
.
m (2.5 kg-m, 18.0 lb-ft)
For installation procedures following the above, refer to WHEEL
HUB / BEARING/ OIL SEAL INSTALLATION of this section.
Tightening torque.
For any tightening torque other than those specified in text, refer
to torque specification table at the end of this section.