Suzuki Canvas SQ416, Руководство по обслуживанию

Страница: 34 / 731

J2
ESCUDO
Type A
Dark green in
pulley color
Type B
Yellow in pulley color
“A”: Indicator
“a”: Normal range
“b”: Limit
“c”: NG range
J20
1. 100 N, 10 kg or 22 lb
2. Fan pulley 3. Crankshaft pulley
4. Adjusting and pivot bolt
0B-6 MAINTENANCE AND LUBRICATION
Water pump, generator, power steering and / or
A/ C compressor (if equipped) drive belt (J20 engine)
Inspection
1) Disconnect negative cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
If any of above conditions are found, replace belt.
3) Make sure that tension indicator “A” is within the range “a”.
If indicator “A” comes into the NG range “c” passing “b”, replace
generator belt with a new one.
NOTE:
Use mirror when checking belt tension of Type A tensioner.
Replacement
Replace belt referring to replacement procedure of generator drive
belt in Section 6H.
Engine cooling fan drive belt (J20 engine)
Inspection
1) Disconnect negative cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
If any defect exists, replace. Check belt for tension.
Cooling fan belt tension
“a”: 5 – 7 mm (0.20 – 0.27 in.) deflection under 100 N, 10 kg
or 22 lb pressure.
NOTE:
When replacing belt with a new one, adjust belt deflection
to 4 – 5 mm (0.16 – 0.19 in.)
3) If the belt is too tight or too loose, adjust it to specification by ad-
justing cooling fan pulley position.
4) Tighten adjusting bolt and pivot bolt.
5) Connect negative cable at battery.
Replacement
Replace belt referring to Section 6B for replacement procedure of
cooling fan drive belt.