Suzuki 2005 DL650K5, Руководство по обслуживанию

Страница: 212 / 701

4-48 FI SYSTEM DIAGNOSIS
Step 2
1) Warm up the engine enough.
2) Insert the needle pointed probes to the HO2 sensor coupler.
3) Measure the HO2 sensor output voltage at the coupler
(between W/G and B/Br wires) when idling condition.
4) Also, measure the HO2 sensor output voltage while holding
the engine speed at 5 000 r/min.
%
HO2 sensor output voltage at idle speed:
0.4 V and less (
+
W/G –
-
B/Br)
HO2 sensor output voltage at 5 000 r/min:
0.6 V and more (
+
W/G –
-
B/Br)
!
09900-25008: Multi circuit tester set
09900-25009: Needle pointed probe set
'
Tester knob indication: Voltage (
(
)
Is the voltage OK?
Step 3
1) Turn the ignition switch OFF.
2) Disconnect the HO2 sensor coupler.
3) Check the resistance between the terminals (White – White)
of the HO2 sensor.
%
HO2 heater resistance: 4 – 5
Ω
(at 23 °C/73.4 °F)
(White – White)
NOTE:
* Temperature of the sensor affects resistance value largely.
* Make sure that the sensor heater is at correct temperature.
!
09900-25008: Multi circuit tester set
&
Tester knob indication: Resistance (
Ω
)
Is the resistance OK?
YES Go to Step 3
NO Replace the HO2 sensor with a new one.
YES
• W/B, O/G, W/G or B/Br wire open or shorted to
ground, or poor
8
,
9
,
N
or
X
connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
NO Replace the HO2 sensor with a new one.
2
V
3
PartShark.com
877-999-5686