Suzuki 2005 DL650K5, Руководство по обслуживанию

Страница: 570 / 701

• Shift the transmission into neutral, turn the ignition switch to
the “ON” position and grasp the clutch lever.
• Press the starter button and allow the engine to crank for a
few seconds, and then measure the ignition coil primary peak
voltage.
• Repeat the above procedure a few times and measure the
highest ignition coil primary peak voltage.
$
Ignition coil primary peak voltage: 150 V and more
'
Tester knob indication: Voltage (
( ( ( (
)
"
Measure ignition coil primary peak voltage (for #2 cylinder) in
the same manner as for cylinder #1.
Ignition coil (for #2 cylinder):
B wire (
+
Probe) – Ground (
-
Probe)
NOTE:
Do not disconnect the ignition coil primary lead wire.
A
Needle pointed probe
$
Ignition coil primary peak voltage: 150 V and more
'
Tester knob indication: Voltage (
( ( ( (
)
"
If the voltages are lower than the standard values, inspect the
ignition coil. (
!
below)
IGNITION COIL RESISTANCE
• Measure the ignition coil resistance in both the primary and
secondary windings. If the windings are in sound condition,
their resistance should be close to the specified values.
$
Ignition coil resistance
Primary: 1 – 5
Ω
(Terminal – Terminal)
Secondary: 25 – 40 k
Ω
(Spark plug cap – Spark plug cap)
)
Tester knob indication: Resistance (
Ω
)
Do not touch the tester probes and spark plugs to pre-
vent an electric shock while testing.
Do not touch the tester probes and spark plugs to pre-
vent an electric shock while testing.
B/W
Peak volt adaptor
Ignition coil
ECM
Battery
New spark plugs
B/W
B
13-66 DL650K7/AK7 (’07-MODEL)
PartShark.com
877-999-5686