Bringing the Benefits of Real-Time Data Collection to the World
Sutron Corporation, 22400 Davis Drive, Sterling, Virginia 20164-4444
34
Command
Description
Command Syntax
(command underlined)
ACCUBAR
®
response (underlined)
"a" represents the
single-character address
XOP Set Operating
Parameters
(Version 2.1
and higher)
aXOPp!
where p is the desired operating
parameter to be set.
values for p
0 Factory default condition which
starts reporting pressure readings
when an RS-232 connection is
made.
1 Disable automatic reading mode
for RS-232
All input values are standard SDI-12
values with polarity sign
attt1
where ttt indicates the command will be
complete in ttt seconds and 1 indicates
one value can be collected.
Note:
a D0 command issued after the
XOP will return the current operating
parameters.
XS
Self-Cal the
Elevation
Offset
aXSdu!
where d is the desired reading for the
sensor and in the units indicated by u.
The ACCUBAR
®
will make repeated
measurements and adjust the
elevation offset to insure the reading
matches the value entered.
Example: 0XS+1007.9+0
(sensor is at 1007.9 mB, adjust offset
to insure this reading)
attt1
where ttt indicates the command will be
complete in ttt seconds and 1 indicates
one value can be collected.
Note:
a D0 command issued after XS is
complete will display the new offset in
units of mB for software versions prior
to 2.0. Version 2.0 and later return the
offset in the current units of pressure.
The offset can also be displayed using
the M3 command.
XT
Set
Averaging
Time
(Version 1.5
and higher)
aXT+t!
t = averaging time in seconds (0 to
240 seconds)
Example: 0XT+10!
(sets the averaging time to 10
seconds)
a0011
indicating the command will be complete
in 1 second and 1 value can be collected
Note:
a D0 command issued after the
XT will return the number of samples to
be averaged during the selected time.
