Installation
VariFrame – Assembly Instructions
page 19
5.3
Installation of components
Follow the instructions regarding the assembly of the table base frame with the
tabletop specified in the schematic diagram of the table base frame (figure 10).
5.3.1
General installation
CAUTION
Electrical components (lifting elements, electrical controllers, manual switches – not
included in the scope of delivery) should be connected or disconnected only with the power plug
pulled out!
Install the table base frame centered under the tabletop (not included in the scope
of delivery).
For the assembly of the lifting columns (not included in the scope of delivery) with
the table base frame, use provided screws only.
Keep electrical cord away from sharp edges and moving parts.
Avoid contact with moisture and heat.
Attach the electrical wires and power cords to the workstation or structure using
cable ties or clips.
IMPORTANT
When laying cables, make sure that the cable is not crushed or stretched. Position the
power cord to prevent tripping hazards. Use only accessories authorized and provided by SUSPA.
First check whether the individual components are damaged. If this is the case, do
not put the table base frame into operation, but have the damaged components
replaced by your supplier.
First check whether the lifting columns are damaged. If this is the case, do not put
them into operation, but have the damaged components replaced by your supplier.
Check whether the controller is damaged. If this is the case, do not put it into
operation, but have the damaged components replaced by your supplier.
Also check the power cable for damage. Make sure to replace damaged power
cables in any case.
