SiO Controller
SUS Corporation
3-10
3.4 Settings
SiO2/SiO2PNP
SiO3
SiO-N1
SiO3.2 SiOt SiO-N3/SiO-N3PNP
* 1: RUN switch, * 2: Timer 1 / Timer 2, Not provided to SiO3.2,SiOt
3.4.1 RUN Switch
Operate the RUN switch to run and stop the program.
Slide the switch to “RUN” (right) to run, and to “STOP” (left) to stop the program.
When the program stops, outputs are all turned OFF.
Be sure to set the RUN switch to “STOP” before registering a program from the SiO-Programmer.
3.4.2 Timer Setting
The SiO controller has two timer setting trimmers.
They are used when T1 or T2 is selected by the program.
*: SiO3.2 / SiOt has no timers.
The maximum value applies when T1 or T2 is selected by the program.
SiO2/SiO2PNP/SiO3/SiO-N1/SiO-N3/SiO-N3PNP
Short
Long
The setting range is 0 to 5 (initial) seconds.
The maximum value can be changed by using the SiO-Programmer.
• Operate the trimmer using a small flat-head screwdriver.
*1
*2
*1
*2
*1
!
CAUTION
*1
*2
*1
*2
*1