Survision Micropak 3, Руководство по установке и настройке

Страница: 10 / 31

10
2 .1 - Assembly and power supply of the NANOPAK Totem
2 .1.1 - Assembly procedure with weak electric current
5. Reclose the totem to finalise the
installation
. Ensure that the screws are
tightenend uniformly.
2. Expose the wires of the brown (positive
and white (Ground) cables. The green
and yellow cables can be connected
to the “dry contact” of the barrier if
necessary.
1. Remove rear part. The NANOPAK is
already installed in the Totem on delivery.
3. If you assemble the Totem directly
on site, the tilt of the camera can be
adjusted by adjusting the 3 screws.
4. The side angle can be adjusted by
pivoting the totem. Adjust the camera
using the configuration procedure on
page 28.
The assembly with weak current corresponds to a 24V power supply located on the outside
of the totem.