Install the bags in the
openings of the col-
lector and secure the
bags with the belt
clips that are attached
to them. See fig.10
Secure upper bags to
the support hooks as
shown in figure 11.
Now you can place the
collection port with
three openings into
inlet port as shown in
fgure 12.
OPERATION INSTRUCTIONS
The RP743A dust collector can be used to vac-
uum-up waste (chips, shavings, etc) after plan-
ing, milling and sawing.
IMPORTANT:
Do not suck metal pieces,
large blocks of wood or pieces of batten into
the collector. Use only accessories designed for
the RP743A. It is more efficient to use the fil-
ter cartridge than the dust bag to collect wood
chips.
• Do not use the RP743A for ink or paint spray,
or explosive substances such as gases or pow-
ders.
• Do not use the RP743A for ink or paint spray,
or explosive substances such as gases or pow-
ders.
•The collection container should be emptied as
required, but at least after each use.
1. Conect hose to the vacuum port on the dust
collector.
2. Connect to the machine on use to collect the
waste.
NOTE: The filtering bag should be cleaned
each time the dust bag is changed.
MAINTENANCE
• The dust collector should be cleaned each
time the collection bag is changed.
• Damaged filters and bags must be replaced
immediately in order to minimize dust disper-
sion in the work area.
MOTOR
Excessive dust can cause the engine to over-
heat. Each effort should be made to prevent
foreign matter from entering the engine.
When operating under conditions that allow
the accumulation of dust, dirt or debris inside
the engine, you must perform a visual inspec-
tion at frequent intervals. Accumulations of
dry powder can usually shut off the engine.
Use a low pressure hose air.
NOTE: Engines used in woodworking tools are
particularly susceptible to the accumulation of
dust and pieces of wood and must be removed
or emptied frequently to prevent interference
with motor ventilation.
11
TECHNICAL DATA
VOLTAGE-FREQUENCY
INLET DIAMETER
BAG DIMENSIONS
SUCTION POWER
SUCTION FLOW
POWER
AMPERAGE
ROTATION SPEED
WEIGHT
120 V ~ 60 Hz
2 x 4
"
(101,6 mm)
19,6" x 33,4" (50 cm x 85 cm)
2 782 Pa
2 300 CFM (42,15 m²/min)
3 HP
18 A
3 400 r/min
59 kg (130 lb)
Fig.11
Fig.12
Fig.10
E N G L I S H •
User's manual
RP743A manual.indd 11
01/07/15 11:47
