FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. 100 L TANK.
2. INDUCTION MOTOR
3. BELT DRIVE
4. HANDLE.
5. HUMIDITY DRAIN VALVE.
6. PNEUMATIC WHEELS.
ASSEMBLY & ADJUSTMENTS
HANDLE
The handle must be fitted in the following
manner:
1. Loosen the screws in each of the handle fix-
ing tubes using an allen key (not included).
2. Insert the two ends of
the handle into the fixing
tubes.
3. Tighten the screws to se-
cure the handle in place, us-
ing an allen key (Fig.1).
WHEELS
Fit the wheels as follows:
1. Position the back of the wheel onto the met-
al bracket located on the tank.
2. Then insert the wheel bolt through the
wheel and then through the hole in the brack-
et under the tank.
3. Attach and tighten the nut with washer, on
the inside of the bracket tightening with two
spanners. Repeat for the second wheel.
NOTE: Tires should be inflated not exceeding
30psi.
RUBBER FEET
1. To fit the two rubber feet
and fit a washer onto the
head of the bolt and pass
the bolt and washer through
the rubber foot as shown in
figure 2.
2. Place the bolt through the
hole in the front bracket and
secure it with the nut and
washer. Tighten the nut with
a spanner, whilst holding the
head of the bolt with your
thumb, do not over tighten.
Repeat for the other rubber foot (Fig.3).
OIL
WARNING: The air compressor must be filled
with oil prior first use. To prevent possible spill-
age of oil during transport, the compressor oil
is supplied in a separate container. It must be
added to the compressor before turning the
compressor on.Failure to add the oil will cause
nonrepairable damage to the compressor and
will void the warranty.
1. Remove the plastic oil fill-
ing cap (Fig.4) located on the
top of the crank case of the
compressor housing.
2. Use the oil supplied to fill
the crank case until the oil
level as seen in the oil level
glass is up to the mid point
of the red circle (Fig.5).
3. Replace the oil filling cap.
Make sure the cap is fully fit-
ted and firmly in position.
OPERATION INSTRUCTIONS
PRE-START ROUTINE
1. Ensure that the location
for the compressor is clean,
dry and well ventilated.
2. Ensure the crank case has
been filled with oil and is at the
correct level, and the air filter
has been fitted (Fig.7 CLOSED).
3. Open the regulated out-
put valve. Open the valve by
rotating the air tap so it is in
line with the air outlet (refer
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
13
E N G L I S H •
User's manual
5
6
3
1
2
4
Fig.6
open
Fig.7
closed
COMP6100A manual.indd 13
23/06/15 14:31
