SureCall Fusion Professional 2.0 | Before installation
1-888-365-6283 | [email protected] | www.surecall.com/ca
12
12
Soft install
Prior to securing the location of any booster components, a “soft install” is recommended as adjustments may be needed
to optimize performance.
Refrain from securing your cable, drilling any holes, etc. until you complete and test the installation of the system.
Tools needed
•
Ladder
•
Drill
•
~2.5“ diameter pole for mounting outside antenna (if needed, SC-MOUNT-JBAR can be purchased separately)
•
Recommended: Surge protected power strip and cable clips
Grounding the outside antenna
SureCall recommends all outside antennas be properly grounded. See "Optional accessories" on page 5.
Power requirements
This booster uses 12v input voltage (power supply part: SC-AC-12V3.8A-B). DO NOT use the booster with a higher or lower
voltage power supply. This can damage the booster, cause personal injury, and void your warranty.
Use of a power strip with surge protection is strongly recommended.
Cable guidelines
The provided cable is 50 ft of SC-400 (part SC-001-50). Longer cable (part SC-001-100) is available if needed. Remember,
a longer cable is helpful only if it allows you to place the outside antenna in a location where you measure stronger
signal.
Routing cable
SureCall recommends that cable connected to the outside antenna run straight down and away from the outside
antenna, not wrapped or draped near it. When securing the cable, be sure to remove any kinks or loops.
Route cable along and through a wall that leads closest to the location of the booster.
SureCall recommends that cable entering the home from an exterior wall use appropriately rated sealant/caulking at the
point of entry.
Following completion of install, weatherproof the exterior coax connections with sealing tape.
English
