19
2. Plug a surge suppressor into a grounded 110VAC wall outlet.
3. Plug the AC end of the power adapter that came with the booster into the surge suppressor.
4. Plug the DC end of the power adapter into the Power port on the booster.
5. Verify that the green Power light is illuminated.
6. If any red Warning light(s) illuminate, immediately power off the booster by either unplugging
the DC power supply from the surge suppressor or by turning off the switch on the surge
suppressor. Increase the attenuation (reduce gain) to the affected channel(s) and try again.
If you are at maximum attenuation and still receiving a warning, then you must verify that all
antennas have been placed according to these instructions and relocate antennas as needed
to eliminate the oscillation. See Section 5.6 for more information.
7. Once the booster is powered on and no red Warning lights are illuminated, you may proceed
to adjust the booster.
CAUTION: ONLY USE THE POWER SUPPLY INCLUDED
WITH THE BOOSTER. USE OF ANOTHER POWER
SUPPLY COULD DAMAGE THE BOOSTER AND/OR
POWER SUPPLY.
CAUTION: DO NOT PROCEED BEYOND THIS POINT
UNTIL THE BOOSTER IS POWERED ON AND NO RED
WARNING LIGHTS ARE ILLUMINATED.
Configuration & Testing
https://www.signalbooster.com | 1-855-846-2654 | [email protected]
