INSTALLATION INSTRUCTIONS
Flex 2G Kit for vehicles (CM-FLEX2GO)
SureCall, Inc.
Page 8
All rights reserved.
If the red LED goes ON, it is the result of one of two factors.
1. More antenna separation is needed. Most likely, the easiest way to achieve
this is to move the magnetic mount antenna farther to the back of vehicle
away from the inside patch antenna.
2. Your vehicle is too close to a cell tower
If unable to provide more antenna separation and the
Alert
LEDs flash after
the initial activation period, lower the dial above the blinking LED by 5dB
(for example, from 50 to 40) and monitor the bars on your cell phone to see
whether reception has improved.
The booster case may become warm during operation. This is normal.
Press any key on your cell phone to refresh communication with the base
station.
WARNING. The booster is rated for 5-15V input voltage. DO NOT use the
booster with a higher voltage power supply. This can damage the
booster and/or cause personal injury.
