7
INSTALLATION
WARNING: A quali
fi
ed service person must
install appliance. Follow all local codes.
WARNING: Never install in a bedroom
or bathroom. Any heating product with a
Btu/Hr rating over 10,000 cannot be used
in a bedroom. Any heating product with a
Btu/Hr rating over 6,000 cannot be used
in a bathroom.
WARNING: Before installing in a solid-
fuel-burning
fireplac
e, the chimney
flue
and
fireb
ox must be cleaned of soot, creo-
sote, ashes, and loose paint by a
qualified
chimney cleaner.
WARNING: Never install the appliance
• in a recreational vehicle
• where curtains, furniture, clothing, or
other
flamma
ble objects are less than
36 inches (91.5 cm) from the front, top,
or sides of the appliance
• in a wood-burning stove
• in high-traffic areas
• in windy/drafty areas
NOTICE: This appliance is intended for
supplemental heating. Use this heater
along with your primary heating system.
Do not install this heater as your primary
heat source. If you have a central heating
system, you may run system’s circulating
blower while using heater. This will help
circulate the heat throughout the house. In
the event of a power outage, you can use
this heater as your primary heat source.
CAUTION: This appliance creates warm
air currents. These currents move heat to
wall surfaces next to appliance. Installing
appliance next to vinyl or cloth wall cover-
ings or operating appliance where impurities
(such as tobacco smoke, aromatic candles,
cleaning
fluids
, oil or kerosene lamps, etc.)
in the air exist, may discolor walls.
IMPORTANT:
Vent-free heaters add moisture to the air.
Although this is
beneficial,
installing
appliance
in rooms
without enough ventilation air may
cause
mildew to form
from too
much
moisture. See Air for Combustion and
V
entilation,
page 4.
CHECK GAS TYPE
Use the
correct
gas type (natural or propane/LP) for your
appliance.
If your gas supply is not
correct
or if you do not
know your gas
type,
do not install
appliance.
INSTALLATION ITEMS NEEDED
Before installing
appliance,
make sure you have the items
listed below.
• external regulator for propane/LP unit only (supplied by
installer)
•
piping (check local codes)
• sealant (resistant to propane/LP gas)
• equipment shutoff valve *
•
test guage connection *
• ground joint union (if required)
• sediment trap (suggested)
• tee joint
•
pipe wrench
• approve
d flexible gas line connector (if allowed by local
codes) (not provided)
* A CSA/AGA design-
c
erti
fi
ed equipment shutoff valve
with 1/8" NPT tap is an
acc
eptable alternative to test gauge
c
onne
c
tion. Pur
c
hase the optional CSA/AGA design-
c
erti
fi
ed
equipment shutoff valve from your dealer.
For propane/LP
units,
the installer must supply an external
regulator. The external regulator will
reduce
incoming
gas
pressure. You must redu
c
e in
c
oming gas pressure to between
11 and 14
inches
of water. If you do not
reduce
incoming
gas pressure, heater regulator damage could occur.
LOG SET PLACEMENT
Place the log set burner system in the center of your fire-
place or fire box. Ensure enough space around the logs
for air circulation.If the fireplace (or firebox) is too small
for the logs, do not install.
