Sur-Gard MLR2000, Руководство по установке

Страница: 7 / 52

3
Section 2 - Quick Start
2.1 Receiver Setup and Operation
2.1.1 Unpacking
Carefully unpack the receiver and inspect for shipping
damage. If there is any apparent damage, notify the car-
rier immediately.
2.1.2 Ethernet Connections
NOTES: Be sure to be properly grounded.
• Take a 50 ohm coaxial cable and connect one end to the
BNC connector (ETHERNET A) of the CPM2000. The
other end of the coaxial cable should be connected to
the BNC connector (ENET A IN) of the backplane.
• Take a 50-ohm coaxial cable and connect one end to
the BNC connector (ETHERNET B) of the CPM2000. The
other end of the coaxial cable should be connected to
the BNC connector (ENET B IN) of the backplane.
• Make sure that there are 50 ohm BNC terminators on
the other end of the T Connectors of the CPM2000
labelled ETHERNET A AND B.
• Make sure that there are 50 ohm BNC terminators con-
nected on the BNC terminals marked ENET A OUT and
ENET B OUT of the backplane. (This should be already
done.)
Figure 1, 60 Line Cards Configuration
firealarmresources.com