Supero SuperWorkstation 7038A-I, Руководство пользователя

Страница: 49 / 122

Chapter 5: Advanced Serverboard Setup
5-9
5-6 Installing Memory Modules
Caution: To prevent any possible damage, exercise extreme care when installing or
removing DIMMs. Be sure to use memory modules of the same type, same speed,
same frequency on the same serverboard. Mixing of memory modules of different
types and speeds is not allowed.
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with P1
DIMMA1. For best performance, please use the memory modules of the same
type and speed in the same bank. See the DIMM Installation Charts on the
following page.
2. Press down the release tabs on the ends of a memory slot. Insert each DIMM
vertically into its slot. Pay attention to the notch along the bottom of the mod-
ule to prevent inserting the DIMM incorrectly.
3. Using both thumbs, gently press down on the DIMM until it snaps into place
in the slot. Repeat for all DIMMs.
4. Reverse the steps above to remove a DIMM from its slot.
Memory Support
The X10DAi supports up to 1024 GB of RDIMM (Registered DIMMs) or LRDIMM
(Load-Reduced DIMMs) ECC DDR4-2133/1866/1600 memory.
Notes: Memory speed support is pending on the CPUs installed on the serverboard.
For the latest memory updates, please refer to the Tested Memory List posted on
our website (http://www.supermicro.com/products/serverboard).
Figure 5-3. DIMM Installation
Socket Key
Release Tab
Release Tab