Supero SuperWorkstation 5035B-T, Руководство пользователя

Страница: 50 / 118

5-22
S
uper
W
orkstation 5035B-T User's Manual
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if an
application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in BIOS.
Note: When enabled, the user needs to
write their own application software in
order to disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
USB Wake-Up Enable/
Disable Jumper Set-
tings (JUSB1/JUSB2)
Pin# Defi nition
1-2 Enabled
2-3 Disabled
USB Wake-Up
Use the JPUSB1/2 jumpers to allow the system to
be "Woken Up" via USB devices by pressing a key
on the USB keyboard or by clicking the USB mouse
of your system. These jumpers are used together
with the USB Wake-Up function in the BIOS. En-
able the jumper and the BIOS setting to use this
feature. See the table on the right for jumper set-
tings. Note : JPUSB1 is for Back Panel USB ports:
0/1/2/3/4/5, and JPUSB2 is for Front Panel USB
ports: 6/7/8/9/10/11.
Note : JPUSB1 should be enabled by default to
allow USB0 and BP USB1 to be woken up from
standby states. However, the default jumper set-
ting for the JPUSB2 is Disabled. When the USB
Wake-Up feature is enabled in the BIOS and
the selected USB ports are also enabled via the
JPUSB jumpers, please be sure to remove all
other USB devices from the USB ports whose
USB jumpers are set to Disabled before the system
goes into the standby mode.