Supero SuperWorkstation 5033C-T, Руководство пользователя

Страница: 54 / 96

6-2
S
UPER
W
ORKSTATION 5033C-T Manual
6-2 Front Control Panel
The front control panel must be connected to the JF2 connector on the mother-
board to provide you with system status and alarm indications. A ribbon cable
has bundled these wires together to simplify this connection. Connect the cable
from JF2 on the motherboard (making sure the red wire plugs into pin 1) to the
appropriate comnnector on the front control panel PCB (printed circuit board).
Pull all excess cabling over to the control panel side of the chassis. The LEDs
inform you of system status - see Figure 6-1 for details. Figure 6-2 shows the
SC733T-350 features included on the front of the chassis. See Chapter 5 for
details on JF2.
Figure 6-1. Front Control Panel LEDs
P o w e r
NIC
HDD
Overheat
Indicates power is being supplied to the system.
Indicates network activity on either GLAN port.
Indicates SATA hard disk/CD-ROM drive activity.
Indicates an overheat condition in the chassis.