Supero SUPERSERVER 8017R-7FT+, Руководство пользователя

Страница: 49 / 104

Chapter 5: Advanced Serverboard Setup
5-21
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a soft-
ware application hangs. Jumping pins
1-2 (the default setting) will cause WD
to reset the system if an application
hangs. Jumping pins 2-3 will generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software in
order to disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable
Jumper JPB1 allows you to enable
the embedded WPCM 450 BMC
(Baseboard Management) Controller
to provide IPMI 2.O/KVM support on
the motherboard. See the table on the
right for jumper settings.
BMC Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 BMC Enable
Pins 2-3 Normal
BMC Reset
Use jumper JPRST1 to reset the BMC
settings on the motherboard. See the
table on the right for jumper settings.
BMC Reset
Jumper Settings
Jumper Setting Defi nition
Closed BMC Reset
Open Normal (Default)