Supero SuperServer 7034L-i, Руководство пользователя

Страница: 57 / 110

Chapter 6: Advanced Chassis Setup
6-9
Figure 6-8. Adding a Component Without a Drive Carrier
Installing Components in the 5.25" Drive Bays
1. Drive bay confi guration
The 7034L-i has two empty 5.25" drive bays above the SATA/IDE drive bays. Com-
ponents such as a fl oppy drive, IDE hard drives or CD-ROM drives can be installed
in these 5.25" drive bays.
2. Mounting components in the drive bays
First power down the system and then remove the top/left chassis cover to access
the drive components. With the cover off, remove the two or four screws that
secure the drive carrier to the chassis (one side only) then push the entire empty
drive carrier out from the back.
Adding a CD-ROM drive : remove the guide plate from right side of the empty
drive carrier and screw it into the right side of the CD-ROM drive using the holes
provided (see Figure 6-8). Then slide the CD-ROM into the bay and secure it to
the chassis with the drive carrier screws you fi rst removed. Attach the power and
data cables to the drive. Replace the top/left chassis cover before restoring power
to the system.
Adding an IDE or fl oppy drive : to add one of these drives, install it into one of the
removed empty drive carriers with the printed circuit board side toward the carrier
so that the drive's mounting holes align with those in the carrier. Secure the drive
to the carrier with four screws then slide the assembly into the bay and secure it to
the chassis with the drive carrier screws you fi rst removed. Attach the power and
data cables to the drive. Replace the top/left chassis cover before restoring power
to the system.
Note: A red wire typically designates the location of pin 1. You should keep the
drive carriers inserted in any unused drive bays to reduce EMI and noise and to
facilitate the airfl ow inside the chassis.