Supero SuperServer 7034L-i, Руководство пользователя

Страница: 55 / 110

Chapter 6: Advanced Chassis Setup
6-7
6-4 Drive Bay Installation
Installing SATA/IDE Drives
The side cover of the chassis must be removed to gain access to the main hard
drive area. First remove the two screws from the back lip of the side cover (this is
the left cover when you look at the chassis from the front.) Grasp the handle and
gently pull the side cover toward the rear to release it from its position. You may
then slide the cover off of the chassis.
Note: Up to four hard drives may be mounted in the main drive section of the 7034L-
i. However, as there are only two SATA ports on the motherboard, the maximum
number of SATA drives you may install is limited to two
.
1. Installing hard drives in the enclosure
Once the side cover has been removed you can remove the bracket enclosure used
to house the four hard drives. Begin by removing the three screws fthat secure
the enclosure to the chassis. Pull the enclosure fi rst toward the rear and then pull
it out from the chassis (see Figure 6-6). Install the desired number (up to four) of
3.5” drives into the enclosure (see note above). Each drive should be secured to
the enclosure with four screws.
2. Mounting a drive in a drive carrier
Once you’ve installed the 3.5” drives into the enclosure, place the enclosure back
into the chassis. Secure it to the chassis with the three screws you removed earlier.
Make all necessary cable and power cable connections. Then slide the side cover
back to position and secure it with the screws. Finish by supplying power to the
system.