Supero SuperServer 7034L-i, Руководство пользователя

Страница: 16 / 110

2-2
S
UPERSERVER 7034L-i User's Manual
Server Precautions
- Review the electrical and general safety precautions in Chapter 4.
- Use a regulating uninterruptible power supply (UPS) to protect the server from
power surges, voltage spikes and to keep your system operating in case of a power
failure.
-
Allow the power supply unit and the SATA/IDE hard drives to cool before touching
them.
-
Always keep the chassis front door and all panels closed when not servicing to
maintain proper cooling.
2-4 Checking the Serverboard Setup
After setting up the the 7034L-i, you will need to gain access to the inside of the
chassis to make sure the serverboard is properly installed and the essential con-
nections have been made. Begin by opening the left side panel (when facing the
front of the chassis). Refer to Figure 2-1 for the following steps.
1. Remove the left side panel of the chassis
First, remove the two screws that secure the back lip of the side panel to the rear
of the chassis. Then grasp the handle at the rear of the panel and pull straight
back about 1/2 inch, at which point the panel should hit a stop. Swing the top
of the panel out and completely lift it away from the chassis. When reinstalling
this panel, make sure the raised holes along the bottom of the chassis fi t into
the long holes in the bottom lip of the side panel.
2. Check the CPUs (processors)
You should have one or two processors already installed into the system board.
Each processor should have its own heatsink attached. See Chapter 5 for
instructions on processor installation.
3. Check the system memory
Your 7034L-i server may have come with system memory already installed.
Make sure all DIMMs are fully seated in their slots. For details on adding system
memory, refer to Chapter 5.
4. Installing add-on cards
If desired, you can install add-on cards to the system. See Chapter 5 for details
on installing PCI add-on cards.