Supero SuperServer 6037R-72RFT, Руководство пользователя

Страница: 60 / 102

6-4
S
UPER
S
ERVER 6037R-72RFT User's Manual
6-3 System Fans
Five 8-cm hot-swap fans (two are rear exhaust fans) provide the cooling for the
system. It is very important that the chassis top cover is properly installed and mak-
ing a good seal in order for the cooling air to circulate properly through the chassis
and cool the components.
System Fan Failure
Fan speed is controlled by system temperature via a BIOS setting. If a fan fails,
the remaining fans will ramp up to full speed and the overheat/fan fail LED on
the control panel will turn on. Replace any failed fan at your earliest convenience
with the same type and model (the system can continue to run with a failed fan).
Remove the top chassis cover while the system is still running to determine which
of the fans has failed.
Replacing System Fans
Removing a Fan
System power does not need to be removed since the fans are hot-pluggable. Replace
the failed fan with an identical 8-cm 12 volt fan (available from Supermicro).
1. Open the chassis and locate the faulty fan. Never run the server for an ex-
tended period of time with the chassis open.
2. Press the release tab on the fan and pull the fan upward.
3. Slide the new fan into the fan housing. Make sure the power connectors are
correctly aligned. The new fan will immediately activate.
Installing the Rear Fans
The rear fans must be installed after the serverboard and air shroud setup.
Installing Rear System Fans
1. Confi rm that the air shroud is correctly placed.
2. Slide the rear fan into the slot as illustrated. The fan release tab should be on
the side closest to the power supply.
3. Make sure that the fan is secure in the fan housing and the housing is cor-
rectly connected to the power supply.