Supero SUPERSERVER 6026T-TF, Руководство пользователя

Страница: 67 / 106

Chapter 6: Advanced Chassis Setup
6-9
6-5 Power Supply
The SuperServer 6026T-TF has a single 650 watt power supply. This power supply
module has an auto-switching capability, which enables it to automatically sense
and operate at a 100V to 220V input voltage.
Power Supply Failure
If the power supply fails, the system will shut down and you will need to replace
the power supply unit. Replacement units can be ordered directly from Supermicro.
See contact information in Chapter 1.
Removing/Replacing the Power Supply
Replace the failed power supply module with the same model (p/n PWS-652-2H),
which can be ordered directly from Supermicro (see Contact Information in the
Preface).
First shut down the system, then unplug the AC power cord. 1.
Remove the chassis cover by pressing the two release buttons on the top of 2.
the chassis (near the front) then push the chassis top rearward about one
inch and lift it off.
To remove the failed power supply, remove the screws at the back that se- 3.
cure it to the chassis and pull the unit straight out with the rounded handle.
Replace the failed hot-swap unit with another power supply unit. 4.
Push the new power supply unit into the power bay until you hear a *click*. 5.
Secure the power supply with the screws you removed previously and fi nish 6.
by plugging in the AC power cord.