Supero SUPERSERVER 6026T-TF, Руководство пользователя

Страница: 18 / 106

2-4
S
UPER
S
ERVER 6026T-TF Manual
2-4 Installing the System into a Rack
This section provides information on installing the SuperServer 6026T-TF into a rack
unit. If the 6026T-TF has already been mounted into a rack, you can skip ahead to
Sections 2-5 and 2-6. There are a variety of rack units on the market, which may
mean the assembly procedure will differ slightly. The following is a guideline for
installing the 6026T-TF into a rack with the rack rails provided. You should also refer
to the installation instructions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer 6026T-TF.
Each of these assemblies consist of three sections: an inner fi xed chassis rail that
secures to the 6026T-TF (A) and an outer fi xed rack rail that secures directly to
the rack itself (B). A sliding rail guide sandwiched between the two should remain
attached to the fi xed rack rail (see Figure 2-1). The A and B rails must be detached
from each other to install.
To remove the fi xed chassis rail (A), pull it out as far as possible - you should hear
a "click" sound as a locking tab emerges from inside the rail assembly and locks
the inner rail. Then depress the locking tab to pull the inner rail completely out. Do
this for both the left and right side rack rail assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
A
B