Supero SuperServer 6025B-8, Руководство пользователя

Страница: 54 / 122

5-20
S
UPER
S
ERVER 6025B-T/6025B-8 User's Manual
Watch Dog Enable/Disable
JWD controls the Watch Dog func-
tion. Watch Dog is a system monitor
that can reboot the system when a
software application is “hung up”. Pins
1-2 will cause WD to reset the system
if an application is hung up. Pins 2-3
will generate a non-maskable interrupt
signal for the application that is hung
up. See the table on the right for jump-
er settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
to disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
3rd Power Supply Fail Detect
Enable/Disable
The system can notify you in the event
of a power supply failure. This feature
assumes that three power supply units
are installed in the chassis with one act-
ing as a backup. If you only have one
or two power supply units installed, you
should disable this (the default setting)
with JP13 to prevent false alarms. See
the table on right for pin defi nitions.
Note: JP10 should be disabled on the
6025B-T/6025B-8, which has only a
single power supply.
3rd Power Supply Fail
Detect Enable/Disable
Jumper Settings (JP10)
Jumper Setting Defi nition
Open Disabled
Closed Enabled
Compact Flash Master/
Slave
The JCF1 jumper allows you to assign
either master or slave status to the
compact fl ash card. See the table on
the right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JCF1)
Jumper Setting Defi nition
Closed Master
Open Slave