6-2
S
UPER
S
ERVER 5017R-WRF User's Manual
Figure 6-1. Chassis: Front and Rear Views
System Reset
6-2 Control
Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the motherboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the motherboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Motherboard Setup."
Control Panel
System LEDs
Main Power
Slim Floppy Drive (optional)
Drive Bays
Power Supply Module
PCI Expansion Slots (w/ riser cards)
I/O Backpanel
Содержание SUPERSERVER 5017R-WRF
