Supero SuperServer 5013G-M, Руководство пользователя

Страница: 20 / 104

2-4
S
UPER
S
ERVER 5013G-M Manual
2-4 Installing the SuperServer 5013G-M into
a Rack (rack hardware optional)
This section provides information on installing the SuperServer 5013G-M
into a rack unit. If the 5013G-M has already been mounted into a rack, you
can skip ahead to Sections 2-5 and 2-6. There are a variety of rack units
on the market, which may mean the assembly procedure will differ slightly.
The following is a guideline for installing the 5013G-M into a rack with the
optional rack hardware. You should also refer to the installation instruc-
tions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails
You may have received two rack rail assemblies (optional) with the
SuperServer 5013G-M. Each of these assemblies consist of two sections:
an inner fixed chassis rail that secures to the 5013G-M (A) and an outer
fixed rack rail that secures directly to the rack itself (B). A sliding rail guide
sandwiched between the two should remain attached to the fixed rack rail
(see Figure 2-1). The A and B rails must be detached from each other to
install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull the
inner rail completely out. Do this for both the left and right side rack rail
assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
Mounting Holes
A
Locking Tab
B