Supero SUPERSERVER 1027TR-TF, Руководство пользователя

Страница: 53 / 130

5-2
S
UPER
S
ERVER 1027TR-TF/1027TR-TFF/1027TR-TQF User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrostatic discharge.
When unpacking the board, make sure the person handling it is static protected.
5-2 Serverboard Installation
This section explains the first step of physically mounting the X9DRT-F/X9DRT-
IBFF/X9DRT-IBQF into the CSE-809BTS-1K28BP chassis. Following the steps
in the order given will eliminate the most common problems encountered in such
an installation. To remove the serverboard, follow the procedure in reverse order.
Accessing the Inside of the System
1. Remove all four screws securing the top cover of the chassis: two at the top
rear of the cover and one on each side lip, also near the back.
2. Place both thumbs in the indentations and push the cover back until it slides
off.
3. Lift the top cover from the chassis to gain full access to the inside of the
server. (If already installed in a rack, grasp the two handles on either side and
pull the unit straight out until the rails lock into place. See Figure 2-5.)
Check Compatibility of Serverboard Ports and I/O Shield
1. The X9DRT-F/X9DRT-IBFF/X9DRT-IBQF in a Twin 1U configuration requires
the use of Supermicro's 1U Twin chassis: the CSE-809BTS-1K28BP.
2. Make sure that the I/O ports on the serverboards align properly with their
respective holes in the I/O shield at the back of the chassis when installing.
Mounting the Serverboard onto the Serverboard Tray
1. Carefully mount the serverboards by aligning the board holes with the raised
metal standoffs that are visible in the chassis.
2. Insert screws into all the mounting holes on your serverboards that line up
with the standoffs and tighten until snug (if you screw them in too tight, you
might strip the threads).
3. Metal screws provide an electrical contact to the serverboard ground to pro-
vide a continuous ground for the system.