Supero SUPERSERVER 1027R-72RFTP, Руководство пользователя

Страница: 56 / 130

5-10
S
UPER
S
ERVER 1027R-72RFTP User's Manual
PCI Slot/Card Configurations
Riser Card Expansion Card Supported
RSC-R1UW-2E16 (left side) 2x PCI-E x16 cards
RSC-R1UW-E8R (right side) 1x low-profile PCI-E x8 card
5-6 Adding PCI Cards
PCI Expansion Slots
The X9DRW-7TPF has two proprietary PCI slot. Riser cards installed to the system
allow you to add PCI expansion cards (see below). The SC119XTQ-R700WB chas-
sis can support the use of two standard size expansion cards and one low-profile
expansion card (with pre-installed riser cards).
PCI Card Installation
Before installing a PCI add-on card, make sure you power off the system first. Begin
by removing the top chassis cover. Two riser cards should be pre-installed into the
system. Remove the screws that secure the riser cards to the rear of the chassis
then lift the riser card assembly from the chassis. Insert the PCI card into the riser
card slot, pushing down with your thumbs evenly on both sides of the card - note
that the add-on card attaches to the riser card with a single screw. After the card
has been installed, reinsert the riser card back into the expansion slot on the board,
then secure it with the same screws you removed previously. Finish by replacing
the chassis cover.
PCI Card Locations
# Expansion Card # Expansion Card
1 Low-profile (2.536"), 6.6" length 3 Full-height (4.2"), 6.6" length
2 Full-height (4.2"), 10" length
1
1
1
3
1
2