Supero SUPERSERVER 1027R-72RFTP, Руководство пользователя

Страница: 54 / 130

5-8
S
UPER
S
ERVER 1027R-72RFTP User's Manual
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
Installing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with slot
P1-DIMM1A. For best performance, install memory modules of the same type
and same speed in the slots as indicated in the tables below.
2. Insert each DIMM vertically into its slot. Pay attention to the notch along the
bottom of the module to prevent inserting the DIMM module incorrectly (see
Figure 5-5).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules
Memory Support
The X9DRW-7TPF supports up to 768 GB registered/unbuffered ECC DDR3-
1600/1333/1066/800 MHz SDRAM or 768 GB of LRDIMM (Reduced Load) DDR3-
1600/1333/1066/800 MHz memory modules.
Figure 5-3. Installing DIMM into Slot
To Install:
Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should align
with the receptive key
point on the slot.
Notch
Notch
Front View