Supero Supero X7QC3, Руководство пользователя

Страница: 25 / 108

Chapter 2: Installation
2-5
2-3 Installing DIMM Modules
Note : Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Also note that the
memory is interleaved to improve performance (see step 1).
DIMM Installation (See Figure 2-2)
1. Insert the desired number of Fully Buffered DDR2 modules into the memory slots,
starting with DIMM #A1. To enhance memory performance, please install two
memory modules of the same type and of the same speed at a time, beginning
with DIMM #A1, DIMM #A2, then DIMM #B1, DIMM #B2.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch along
the bottom of the module to avoid incorrect memory installation.
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules (see step 1 above).
X7QC3
To Install: Insert
module vertically
and press down until
it snaps into place.
Pay attention to the
alignment notch at
the bottom.
Figure 2-2. Installing FBD DDR2 Memory Modules
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Top View of DDR2 FBD Slot
Memory Support
1. The X7QC3/X7QCE supports up to 192 GB fully buffered (FBD) ECC DDR2
667/533 in 24 DIMM slots (4 channels, two branches). Single memory scheme,
two-way interleaved memory scheme and four-way interleaved memory scheme
are supported. Using four-way interleaved memory will result in best memory
performance. Please use memory modules of the same type, same speed, same
timing and same organization on a motherboard.
DDR2 FBD Memory
Notch
Notch
Release Tab
Release Tab
Note: Notch should
align with the
receptive point on
the slot.